latch
switch
hołd
ront door
pl
(1)
Slip
on the connecting lever
arm
and the working lever into the switch holder.
(2) Assemble the interlock switch and pilot switch to the switch holder,
mąkę
surę
they
arę
assembled correctly.
(3)
Tightly
fix the holder with
two
screws.
(4) Check the position of the hook and the switch holder.
screw
Close
the door, push and
puli
the Iow and up
part
of the
door to check whether the door is flexible.
If
it does, back
and front position of the holder should be adjusted.
Provided the up hook is
loose,
the door should be pushed
morę
closely to the
oven,
and
puli
the holder inside closely
after
loosen the screw
which
fix the
holder,
then, tighten the
screw and check whether it is
still
loose. If it is not or the
loose is minor, it
would
be OK. Open the door, then
close
it
lightly,
check whether the hook is in position, if not,
readjustment is needed. If the loose is at
Iower
part of the
door, the adjust methods is the same with the above said
steps but the screw is the one
below
(FIG.4 -
21).
4.11
THE
CONTROL
PANEL OF
A
TYPICAL
WICROWAYE
OVEN
Puli
out the power
pług.
Take off the
cabinet.
Discharge
between
one end of the capacitor and the
light tough switch
control panel
Fig. 4-22
light tough switch
control panel
baseboard with a screwdriver.
Means of dismantling the PC board and door release
mechanism:
(1)
Puli
out
all
the terminal
pług
of the PC board.
(2) Loosen out the two screws which fix the control panel
with a
"+"-
screwdriver (FIG.4 -6).
(3) Take off the control panel.
(4) Take off the three
"+"-
screws which fix the PC board
as the FIG.4 - 22.
(5) Take off the rangę terminal
plugs
as FIG.4 - 24 shown,
that is press the two places according to the arrow
direction at the figurę,
while
puli
it up about 2mm, then off
the
rów
plastic board.
(6) Take off the PC frame.
(7) Tear off the undried glue of the light touch switch (FIG.4
-23).
to assemble the PC board and door release mechanism,
(1)
Tear off the undried glue patch of the light tough switch
(1) and (2) as the
Fig.shown,
and place them into the
rectangle hole of the
surface
of the plastic board.
(2) After uprighted the light tough switch, tear off the
protective paper on the back, and stick it on the plastic
board smoothly.
(3) Tear off the protective paper of the light touch switch (2), and stick the switch on the back of the plastic board
smoothly.
(4) Assemble in the PC frame and PC board as FIG .4
-22,
and fix them with three
"+"-
screwes.
(5) Fix the rangę wires as
FIG.4-24,
the means
arę:
Insert
the rangę wires first,
mąkę
surę
that its notch is tallied with
the flange of the
rów
seat, then, press it down to its normal
15
Fig. 4-23
Fig. 4-24
To Next Page
Loading...
