sealant sparingly, avoiding excess finding its
way into the shower operating parts.
4. With the isolating valve connected,
flush the pipe work through to remove
any particles etc,
before making the final
connection to the shower.
Blockage in the water ways (particularly the
handset and inlet filter) will prevent the
heater working properly.
Note: You may be charged for a service call
if it is due to incorrect installation
.
5. The shower is designed to have an open
outlet and should only be used with the
manufacturers recommended fittings.
Do not connect the handset until after the
shower front cover and detachable lower
section are fitted.
To Next Page
Loading...
