Galil Motion Control DMC-4040 User Manual

Operands
Most DMC-40x0 commands have corresponding operands that can be used for interrogation. Operands must be
used inside of valid DMC expressions. For example, to display the value of an operand, the user could use the
command:
MG ‘operand’ where ‘operand’ is a valid DMC operand
All of the command operands begin with the underscore character (_). For example, the value of the current
position on the A axis can be assigned to the variable ‘V’ with the command:
V=_TPA
The Command Reference denotes all commands which have an equivalent operand as "Operand Usage". Also, see
description of operands in Chapter 7 Application Programming.
Command Summary
For a complete command summary, see Command Reference manual.
http://www.galilmc.com/support/manuals.php
Chapter 5 Command Basics ▫ 70 DMC-40x0 User Manual

Galil Motion Control DMC-4040 Specifications

General

Brand	Galil Motion Control
Model	DMC-4040
Category	Controller
Language	English