EasyManua.ls Logo

Gallagher 026015 - Charging the Ba Ery

Gallagher 026015
108 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
2
Gallagher TW- Weigh Scale Quick Start Guide
English
SPECIFICATIONS
Opera ng Temperature -20
o
to 50
o
C
-5
o
to 120
o
F
Environmental Protec on Ra ng IP67
Input Voltage 12 V DC
Es mated ba ery run me 16 hours at 60% brightness
12 hours at 100% brightness
CHARGING THE BATTERY
To ensure op mum performance of the TW-, the internal ba ery may need to be
charged for up to 16 hours before rst me use.
Important: If the TW- is to be stored for an extended period, this should be in
a cool dry place with a fully charged ba ery.
Always charge the ba ery indoors.
1. Connect the power adapter at the base of the unit and plug the TW- into a
power outlet and switch ON. The charging icon will display on the screen.
Warning: The power adaptor is intended for indoor use only. Do not expose to
rain or dampness.
2. When the charge shows 100% the TW- is ready to use with or without the
power adapter.
Note:
When the TW- is in use, the ba ery icon
will display and show remaining charge.
When using the scale and the charge level falls
below 10% the ba ery icon will ash with a red
outline. You will have about 30 minutes to complete the weighing session
before the TW- must be charged.
When the charge level becomes cri cal the unit will shut down.
To check remaining run me at current se ngs, from the Home screen, go to
Se ngs > About > Ba ery.

Table of Contents

Related product manuals