3E2374 Sheep Auto Drafter User Manual
Page 38
• Pressing Retain/Release will put it into Manual Release Mode.
• The unit will continue operations from the point it was halted, (e.g. if
you were weighing animals and an animal had just been captured
then after restarting it would weigh the animal and release it).
Using without weighing (no scale attached)
Occasionally you may wish to use the Sheep Auto Drafter without the scale
indicator attached, (e.g. if you are just wanting to record animals' EIDs). The
Sheep Auto Drafter can still operate without the scale indicator.
To set up the Sheep Auto Drafter without the scale indicator
1. Connect the loop back cable into the socket on the Control Bridge, instead
of the scale indicator, so that the load cells are not connected (see Figure
19).
Figure 19. Attaching the loop back cable.
To Next Page
Loading...
