Gallagher M6000i User Manual

English
Gallagher 3E5260 M6000i/M12000i Energizer User Manual
16
Current Alarm
The factory default seng is current alarm disabled (shown by --). To improve
your ability to nd faults before your fence becomes ineecve (voltage too low),
Gallagher recommend seng the current alarm 10A above normal operaon.
Many events can cause the current to increase, including rainfall, grass growth,
broken fences and failed insulators. If the current goes above the alarm level you
have set, then the Energizer icon ( ) will ash and the status LED will ash red.
Controller showing the energizer in current alarm
Status LED
ashes red
Adjusng / Turning O Alarms
a) Press the setup buon ( ).
b) Press the navigaon buons (< or >) to move the zone indicaon arrow ( )
over the desired zone, which will ash when selected.
c) Press (- or +) to adjust the zone alarm level.
d) To disable an alarm press (-) unl the display shows (- -).
e) To exit, press the setup buon ( ) or wait 10 seconds.
Controller showing the default energizer alarm setup with
current disabled and voltage at 3.0KV

Gallagher M6000i Specifications

General

Brand	Gallagher
Model	M6000i
Category	Power Supply
Language	English