8
3E4723 Gallagher MBS100 MBS200 MBS400 MBS800 Mul -Power User Manual
INSTALLATION INSTRUCTIONS
Step 1. Mount the Energizer
Mount the energizer on a post or wall, out of reach of children. Install in a
place where there is no risk of the energizer incurring mechanical damage,
and where there is no risk of the leads being chewed by animals. If possible,
install away from heavy electrical equipment e.g. pumps or other items that
may cause electrical interference.
Permanent Installa on
a) Drill a single hole using a 4mm (5/32”) diameter drill for mber walls, or
a suitable wall plug for brick and concrete walls. (Figure 1.)
b) Fix the 32mm screw provided into the wall leaving the head of the screw
3mm (1/8”) out from the wall. (Figure 2.)
c) Place the energizer over and slide down onto the moun ng screw.
(Figure 3.)
d) Secure energizer by fi xing the 50mm screw into the wall through the
hole in the handle. (Figure 4.)
Figure 1
Figure 2
Figure 3
Figure 4
9Power connec on Connect 12V ba ery leadset or external mains
power adaptor.
10 Steel post mount Enables moun ng on T-Post, Y Post or similar
To Next Page
Loading...
Need help?
General
