Need help?Do you have a question about the Gambro COBE 2991 and is the answer not in the manual?
General| Category | Medical Equipment |
|---|---|
| Manufacturer | Gambro |
| Model | COBE 2991 |
| Power Requirements | 100-240 VAC, 50/60 Hz |
| Operating Temperature | 15 to 30 °C |
| Storage Temperature | 0 to 40 °C |
| Relative Humidity | 20 to 80% (non-condensing) |
Highlights important safety considerations and precautions for using the tubing set.
Describes the EXCESS PRESSURE status light and causes.
Lists and describes circuit breakers.
Explains audible alarms.
Describes HELP 1 and HELP 2 messages and actions.
Provides step-by-step instructions for installing the set.
Provides instructions for removing the set.
Explains hydraulic system priming.
Details removing the bowl cover when the bag is overfilled.
Addresses Excess Pressure alarms.
Explains handling overfilled bags.
Explains how to troubleshoot problems.
Covers troubleshooting of alarms.
Covers troubleshooting of non-alarm issues.
Lists causes and actions for the Excess Pressure alarm.
Details the HELP 1 message.
Details the HELP 2 message.
Addresses continuous flashing STOP RESET light.
Addresses continuous ON STOP RESET light.
Addresses Agitate/Wash-In operation not working.
Addresses centrifuge agitation issues.
Addresses issues with removing the bowl cover.
Addresses erratic centrifuge speed.
Addresses EXCESS PRESSURE light issue.
Addresses hydraulic fluid leaks.
Addresses LED program board issues.
Addresses cycle advancement failure.
Addresses POWER light issue.
Addresses READY light issue.
Addresses rotating seal failures.
Addresses Start/Spin not advancing to Supernatant-Out.
Addresses Start/Spin operation not working when light is illuminated.
Addresses Start/Spin operation not working when light turns off.
Addresses Start/Spin operation not working when light is not illuminated.
Addresses Supernatant-Out operation not working.
Addresses Supernatant-Out not advancing to Agitate/Wash-In.
Addresses inaccurate supernatant-out volume.
Addresses valves not moving as expected.
To Next Page
