26
E3/VS line
Operating principle
Chapter 2 - Installation
A refrigerator works by extracting heat from the space to be refrigerated and to release this in the surrounding
area. For maximum air circulation it is recommended to allow at least 10 cm space around the refrigerator.
Be very careful never to obstruct the air inlets and outlets.
The advised maximal height of the load is marked with the load lines on the inside of the cabinet.
Installing the appliance
1 Place the product in the desired position on a at surface.
2 Place a water level on the product.
3 The product is best placed with feet (1) to provide adequate air circulation around the cabinet.
This guarantees optimal operation of the product as well as a reducing energy consumption.
The legs can be used to level the product properly.
4 Adjust the stands (1) with 6 mm Allen wrench in the openings (2) until the product is level
5 Tighten the screws (3) of the foot pieces (1), at the bottom, with a wrench, when the adjusting device is
not accessible from the inside.
6 Plug the openings (2) on the inside with the supplied caps
If the feet (1) are not mounted, then ll the holes in the bottom with the supplied insulation caps (2).
This is to prevent condensation and loss of energy.
To Next Page
Loading...