Gamko E3 VS - Troubleshooting Common Issues

34
E3/VS line34
E3
Troubleshooting
Attention
Always remove the plug from the socket when carrying out repairs.
The appliance does not start.
• Check the powerplug.
• Check the power switch next to the thermostat.
• Restore power by possibly replacing a faulty fuse or switch.
• Please notify your service partner.
Temperature is too high, Despite the correct thermostat set point.
• Check that the condenser is clean (see Chapter 4: Maintenance).
• Check that fan rotates
• Remove any objects that may block the air ventilation.
• Check magnetic door seal, clean or replace if necessary.
• Defrost evaporator.
• Thermostat is defective. Please notify your service partner.
Temperature is too low, Despite the correct thermostat set point.
• Thermostat is defective. Please notify your service partner.
Water spillage
• Make sure doors / drawers close properly.
• Check that any holes made during installation are well sealed.
• Make sure the appliance is level.
• Defrost regularly - perhaps additional manual defrost (see manual thermostat).
• Please notify your service partner.
34
E3/VS line