G&G IMAGE M4100 Series User Manual

147 pages

To Next Page

To Previous Page

Note：

• If you do not know the SSID of access point (wireless router), please click “Print Wireless

Network Information Page” to view the SSID of the needed access point (wireless router).

• If the printer cannot be used normally after wireless network setup is finished, please

install the drive again.

3. Use WPS connection.

Select “No, I don't have a USB cable” in the interface below and then click “Next”.

1) Use WPS method to perform steps below to start wireless network on printer. (Please refer to

Chapter 5.1.2 for detailed WPS configuration)

Questions and Answers:

Need help?

Do you have a question about the G&G IMAGE M4100 Series and is the answer not in the manual?

General