Gantner GL7p - GL7 p Signalization Summary

GL7p - Battery-powered, door-mounted electronic locker lock GL7p
Operation
62 HB_GL7p--EN_12 www.gantner.com
6.6 Summary of GL7p Signalization
The electronics of the GL7p are activated when the lock button is pressed in. The activation is signaled by the LED
at the top of the GL7p (LED flashes blue). Immediately thereafter, the following lock states are signaled via the
same LED and the integrated beeper.
LED
Beeper
Meaning
Blue flash
-
Lock ready to read a data carrier
Red flash
-
- No authorization
- Error
Green flash
-
- Data carrier accepted
- Operation successful
Green flash
Ascending beeps
Battery replacement successfully completed; lock operating in
normal operating mode again
Flashing red/green
-
Only in configuration mode; lock waiting to read a data carrier
5 x red flashes
5 x beeps
Battery change required
1 x brief white flash
1 x beep
Pressing of a PIN code key has been detected
Table 6.2 - Summary of the LED and sound signals