| 12
When you turn on your RC1xx controller, the display shows a series of
messages (To nd a list of their meanings, refer to the User Manual). Two
segments of the display then ash alternately.
Press and hold the SEL button for one second, then follow the keystrokes
overleaf.
CH1 is displayed. Use the and
buttons to scroll to rAt.
Press the SEL button.
Use the and buttons to select
the method you require to set
the rating of your light: CUR for
current and VOL for voltage.
Use the and buttons to set
the current in Amps or the voltage
in Volts. Press the SEL button.
Your light’s rating is set up.
8 Safety precautions
Read this before using the RC1xx. Always observe the following safety
precautions. If in doubt, contact your distributor or Gardasoft Vision. The
following symbols mean:
Warning: Read instructions to understand possible hazards
To Next Page
Loading...
