GARDASOFT RC100 - Pulse and Duty Cycle Limits; Pulsed Output; Internal Trigger

9 |
www.gardasoft.com
Switched - the trigger input can be used to switch the output current on
and o.
Note: This Quick Start Guide is mainly concerned with pulse mode
operation of your RC1xx controller. For more information on the other
modes of operation, see the User Manual at www.gardasoft.com.
The set-up is non-volatile, so your RC1xx controller will resume the same
operation after a power cycle.
4.1 Pulse and duty cycle limits
In both pulsed and switched modes, the pulse width and duty cycle are
internally limited to prevent damage to the light. The brightness, pulse
width, and duty cycle can all be set. For more information refer to the
User Manual.
If necessary, your RC1xx controller limits the duty cycle by ignoring
triggers that occur too soon after the previous trigger. If the internal
temperature gets to high, the display shows FAt.
4.2 Pulsed output
The output is o by default. When your RC1xx controller is triggered, it
pulses after a delay.
The re-trigger delay is the minimum permitted time from one trigger to
the next; this can be set in multiples of 100µs. Any triggers that occur too
soon after the previous trigger are ignored.
You can congure the delay, pulse width, re-trigger delay, and pulse
intensity. For more information, refer to the User Manual.
4.3 Internal trigger
An internal trigger timer is available for continuous triggering in pulse
mode. You can congure the period of this trigger’s timer. For more
information, refer to the User Manual.