| 14
IEC 60950-1, IEC 60335-1, IEC 61010-1, IEC61558-1,-2,-16. The PSU may
also be approved to equivalent or superior safety standards.
» Any energised conductors derived from mains electricity must also have
Safety Extra Low Voltage (SELV) output.
» At maximum ratings the temperature of the enclosure can exceed 65°C.
Therefore, either all cabling must be rated to at least 100°C, or all cabling
must be additionally insulated by an appropriately rated heat resistant
sleeve.
» Power supply cabling to the controller must be rated to at least 6A.
» The cabling from the channel output to the load must be rated higher
than the maximum channel output current.
» If the controller is setup incorrectly, or in the event of failure, the energy
provided by the power supply to the controller may become directly
connected to any or all output channels. You must consider this during
installation, and if necessary, provide adequate protection.
» The DC power supply to controller must be externally fused to 3A using a
slow blow fuse (T3AH, 50V).
» The installer must provide a clearly marked, nearby and easily accessible
switch as part of the installation to allow the controller to be disconnected
from its energy source on both power conductors.
» Transients caused by inductive loads must be suppressed externally to
the RC1xx.
Warning: This is a Class A product. Its use in residential areas may
cause radio interference, and such use should be avoided unless special
measures are taken by the user to restrict emissions to a level that allows
the reception of broadcast transmissions.
8.3 General
The RC1xx must not be used in an application where its failure could
cause a danger to personal health or damage to other equipment.
If the equipment is used in a manner not specied by the manufacturer,
the protection provided by the equipment may be impaired.
To Next Page
Loading...
