Gardena 4030 - Basic Operation and Time Setting; Setting the Controllers Date and Time

19
GB
The two screws (not supplied) for attaching the Watering
Controller have to be screwed into place 80 mm apart and the
screw head diameter must not exceed 8 mm.
1. Screw the screws
6
into the wall 80 mm apart.
2. Attach the Watering Controller.
3. Release snap lock
1
and open cover
2
(see “Connecting
your Watering Controller” ) and mark hole for screw
6
of the
elongated hole
7
.
4. Screw the screw
6
into the elongated hole
7
for fixation.
5. Close cover
2
and let snap lock
1
engage.
5. Operation
5.1 Basic Programming
Date and Time (Time Key)
You can end the programming mode at any time by pressing the
Time key.
You must set the date and time before you can set the watering
programs. The day of the week is selected automatically using
the date. When the Time key is pressed, all the valves are clo-
sed as a precaution.
1. Plug in the power supply unit – or – press the Time key.
YEAR
and date-year flash in the display.
2. Select the date-year using the ▲-▼ keys (e.g.
2010
) and
confirm by pressing the OK key.
MONTH
and date-month flash.
3. Select the date-month using the ▲-▼ keys (e.g.
05
) and
confirm by pressing the OK key.
Day
and date-day flash.
4. Select the date-day using the ▲-▼ keys (e.g.
23
) and
confirm by pressing the OK key.
TIME
and time-hours flash.
5. Select the time-hours using the ▲-▼ keys (e.g.
12
hours) and
confirm by pressing the OK key.
TIME
and time-minutes flash.
6. Select the time-minutes using the ▲-▼ keys (e.g.
30
minutes)
and confirm by pressing the OK key.
The date and time have been set and the main level is displayed.
Wall-mounting the Watering
Controller:
Setting the date and time:
1.
2.
3.
4.
5.
6.
6
6
7
6