25
GB
Wintering / Storage:
Important:
Disposal:
(in accordance with
Directive 2012/ 19 /EU)
6. Putting Out of Operation
The watering controller is frost-proof. No measures are required
when frost commences. Legibility of the display is restricted
below 0 °C.
v Check battery status display before the power supply unit is
disconnected.
Only dispose of batteries when they are flat.
v Return flat batteries to the place you bought them or
dispose
of them properly at your local recycling/disposal centre.
The product must not be added to normal household waste. It
must be disposed of in line with local environmental regulations.
v Important: Make sure that the unit is disposed of via your
municipal recycling collection centre.
7. Trouble-Shooting
Fault Possible Cause Remedy
No display External temperature below v Wait until the external air
0 °C or above +60 °C. temperature returns to the
operating temperature range.
AC OFF
The power supply unit is not v Plug the power supply unit
is indicated on the display plugged in. into a mains socket.
(the programs are retained)
Overload
The power supply is over- v Only so many valves may be
is indicated on the display loaded because valves from opened at the same time that
(the programs are retained). other manufacturers have the total power consumption
been used. does not exceed 800 mA.
Cabling of the valves has a v Cable the valves properly
short circuit. (see 4. Initial Operation
“Connecting the valves”
).
The Watering Controller is reset to the default setting and
all the program data is deleted.
1. Press and hold down the OK key.
2. Also press and hold down the Channel key for 3 seconds.
The lock symbol is displayed.
• All the symbols of the display light up for 2 seconds.
• The program data for all programs is deleted.
• The date and time are retained.
• The key lock is cancelled.
A reset can be triggered at any time.
Tip: Should you have any questions about operating and
programming your Watering Controller, please do not hesitate
to contact your nearest GARDENA Service Centre.
Reset function:
To Next Page
Loading...
