To Next PageTo Next Page
Need help?Do you have a question about the Gardena FP 2500 E and is the answer not in the manual?
General| Brand | Gardena |
|---|---|
| Model | FP 2500 E |
| Category | Water Pump |
| Language | English |
GARDENA Fountain Pumps are designed for private use and are not for operating watering tools.
GARDENA Fountain Pumps are not for constant use in industrial sectors or for pumping aggressive substances.
Use residual current device (≤ 30 mA). Ensure solid ground. Disconnect from mains before work.
Use rubber sheathed cable (H05 RN-F). Extension cables must meet DIN VDE 0620. Check line voltage.
Screw nozzle pipe and water feature insert. Options include cascade, waterbell, jets of water, foaming spring.
Attach additional filter to extend maintenance interval and improve water feature life.
Install pond edge controller for adjusting water features and cleaning the filter housing from the pond edge.
Place pump in water, extend pipe, connect plug, set regulator, and attach water feature insert.
Fill hose, secure controller, and set regulator. Ensure the controller is covered with water.
Connect additional consumers like gargoyles. Adjust water quantity via regulator.
Disconnect pump. Clean nozzle pipe and water feature insert in clean water.
Clean filter housing with water. Clean controller filter under/out of water based on soiling.
Disconnect pump. Remove housing, clean impeller, reassemble.
Addresses issues like no operation, reduced flow, and provides solutions.
Remove pump before frost, clean, and store in a frost-free location filled with water.
Dispose of product according to local environmental regulations, not in household waste.
GARDENA guarantees the product for 3 years covering material or manufacturing faults if handled properly.
