Gardena FP 2500 E - Maintenance; Side outlet usage; Clean water feature components; Clean filter housing and controller filter

12
GB
Clean filter housing:
Clean the filter of the pond
edge controller:
Clean water feature insert
and nozzle pipe:
Additional consumers (e.g. gargoyles) can be connected to the
side outlet
B
(1/2”, 3/4” and 1”nipple) The quantity of water can
be adjusted via the regulator
C
.
Note: The ball joint
D
can be used to align the water feature so
that it is vertical.
5. Maintenance
Warning! Electric shock!
V Disconnect the pump from the mains before working on it.
Do not use any hard objects or powerful detergents for cleaning
the set!
1. Unscrew nozzle pipe.
2. Unscrew water feature insert and remove from nozzle pipe.
3. Clean nozzle pipe and water feature insert in clean water.
1. Take water feature pump out of the water.
2. Unlock snap fastenings
6
and open up the filter housing
5
.
3. Clean filter housing
5
with a jet of water.
4. Hook the halves of the filter housing into each other and close.
Do not use any hard objects or powerful detergents for cleaning
the set!
Light soiling:
v Clean the filter surface of the pond edge controller under
water.
Heavy soiling:
1. Disconnect the pond edge controller from the hose underwater
to prevent air from being drawn in.
2. Take pond edge controller out of the water, open and clean.
3. Reconnect the pond edge controller to the hose under water.
Side outlet:
B
C
D
7
5
6