Gardena T 1030 card - 6. Trouble-Shooting; Red LED is illuminated for 5 seconds (reading error); Both LEDs are flashing (Opening manually impossible); Watering has not been initiated

11
GB
6. Trouble-Shooting
Fault Possible cause Remedy
Red LED is illuminated Programming card has been re- v Remove the programming
for 5 seconds moved too fast or too slowly when card at a constant speed.
(reading error) reading in the programming data.
Dirty or wet programming card. v Clean / dry programming
card.
Slide on the programming card is v Engage the slide on the
not in an unambiguous position. programming card.
Both LEDs are flashing Battery level is too low. v Insert new alkaline batteries.
(Opening manually impossible)
Valve is blocked. 1. Remove batteries.
2. Remove blockage and
clean filter.
Watering has not been Water tap off. v Turn tap on.
initiated
Sensor active (shows there v See instructions for
is sufficient moisture). the sensor.
Battery flat after working Alkaline batteries were v Use alkaline batteries.
for a short time not used.
If you have any other problems with your Water Timer, please contact GARDENA Service.