Mealstream Ovens Pt. No. 32Z3403 Issue 16
Page 37
M6 nut runner
M5 nut runner
Tools required for removing shelf runners and element cover plate.
Please Note:
DO NOT attempt to carry out the following procedure
unless you have the following tools.
M6 x 12mm
stainless steel Hex
Head screw
Pt No. 80T7133
M5 stainless steel
dome nut
Pt. No. 80X7025
Shelf runner
Element cover plate
1. Loosen the rear fixings screws of both shelf runners with M6 nut runner.
2. Remove the front fixings screws of both shelf runners with M6 nut runner.
3. Pull the shelf runners forwards away from the rear screws.
4. Remove the 4 off M5 dome nut securing the Element cover plate.
5. Lift the Element cover plate out taking care to not damage the temperature sensor pocket.
PROCEDURE
FOR REMOVING SHELF RUNNERS AND ELEMENT COVER PLATE
To Next Page
Loading...
Need help?
General
