Need help?Do you have a question about the Garmin GHC 10 and is the answer not in the manual?
Customizing the angle increment for step steering.
Using predefined patterns for maneuvers like zigzag, circles, U-turn, and MOB.
Steering based on GPS waypoints or routes.
Steers the boat according to a route defined on the chartplotter.
Maintaining a constant heading without manual helm control for sailboats.
How to modify the boat's heading using the autopilot for sailboats.
Maintaining a bearing relative to the current wind angle.
Performing tack or gybe maneuvers using heading or wind hold.
Configure user-specific autopilot parameters like Shadow Drive, Sea State, and tack/gybe.
Information on initial setup and advanced configuration of the autopilot.
Customizing the angle increment for step steering.
Using predefined patterns for maneuvers like zigzag, circles, U-turn, and MOB.
Steering based on GPS waypoints or routes.
Steers the boat according to a route defined on the chartplotter.
Maintaining a constant heading without manual helm control for sailboats.
How to modify the boat's heading using the autopilot for sailboats.
Maintaining a bearing relative to the current wind angle.
Performing tack or gybe maneuvers using heading or wind hold.
Configure user-specific autopilot parameters like Shadow Drive, Sea State, and tack/gybe.
Information on initial setup and advanced configuration of the autopilot.
General| Waterproof | Yes |
|---|---|
| NMEA 0183 Input Ports | 2 |
| NMEA 0183 Output Ports | 2 |
| Garmin Marine Network Ports | 1 |
| Touchscreen | No |
| Water Rating | IPX7 |
| Compatibility | Compatible with Garmin autopilot systems |
| Mounting | Flush mount or bracket mount |
| Interface | Garmin Marine Network |
| Operating Temperature | -15 to 70 °C |
| Power Supply | 10-30 VDC |
| Voltage Range | 10-30 VDC |
To Next Page
