Garmin GHC 50 - Installation Instructions Manual

GHC
™
50
INSTALLATION INSTRUCTIONS
Important Safety Information
WARNING
Failure to follow these warnings, cautions, and notices could result in personal injury, damage to the vessel or
device, or poor product performance.
See the Important Safety and Product Information guide in the product box for product warnings and other
important information.
CAUTION
To avoid possible personal injury, always wear safety goggles, ear protection, and a dust mask when drilling,
cutting, or sanding.
To avoid possible personal injury or damage to the device and vessel, disconnect the vessel's power supply
before beginning to install the device.
To avoid possible personal injury or damage to the device or vessel, before applying power to the device, make
sure that it has been properly grounded, following the instructions in the guide.
NOTICE
For the best possible performance, the device must be installed according to these instructions.
When drilling or cutting, always check what is on the opposite side of the surface to avoid damaging the vessel.
Tools Needed
• Drill and drill bits
◦ Preparing the surface for cutting:
9mm (
3
/
8
in.) bit
◦ Installs using wood screws:
2.5mm (
3
/
32
in.) bit
◦ Installs using the nut plate:
3.5mm (
9
/
64
in.) bit
4mm (
5
/
32
in.) bit
• #2 Phillips screwdriver
• Jigsaw or rotary tool
• File and sandpaper
• Marine sealant (recommended)
GUID-9CEF40E7-A1D9-42A3-9EB1-DF9CF3B47115 v1April 2022