Need help?Do you have a question about the Garmin GTX 335 w GPS and is the answer not in the manual?
General| Brand | Garmin |
|---|---|
| Model | GTX 335 w GPS |
| Category | Marine Radio |
| Language | English |
Overview of installing GTX 335 as a minor alteration per STC SA01714WI.
Defines key terms and abbreviations used throughout the manual.
Details manual applicability to GTX 335 installation per STC SA01714WI.
Explains ADS-B benefits and GTX 335 transponder functions.
Covers equipment and hardware for GTX system installation.
Lists power requirements and other technical details for GTX 335.
Lists Garmin and FAA documents relevant to installation.
Notes that STC data is available for download for permission letters.
Refers to AFMS for limitations and compliance with AC 23.1309-1E.
Outlines restrictions for GTX 335 installation, location, and environment.
Planning steps and notes for GTX installation, emphasizing avionics practices.
Lists standard Garmin kit items like connector kits.
Lists necessary installation items not provided by Garmin.
Offers advice for installation in conjunction with avionics practices.
Details required components for GTX 335 ADS-B Out.
Recommends crimping tools for D-Sub connectors used with GTX transponders.
Lists essential test equipment required for the installation process.
Addresses external sensors and data interface considerations.
Provides guidelines for labeling new components installed for the GTX 335.
Discusses connecting external switches for GTX 335 functions.
Offers guidance for transponder and GPS antenna installations.
Details requirements for GPS antenna cable loss and shielding.
Covers circuit protection, power distribution, and audio interference.
Provides guidance on supporting and protecting wiring.
Explains electrical bonding requirements for equipment to aircraft ground.
Outlines the process for performing an Electrical Load Analysis.
Details physical mounting requirements, location, and rack modifications.
Explains computing weight and balance after GTX 335 installation.
Covers wiring, tools, power distribution, and cable preparation.
Guides installation of Altitude Encoder and configuration module.
Describes final steps for installing the GTX unit into the rack.
Provides guidance on completing the Airplane Flight Manual Supplement.
Details how to check GTX 335 software version and operational precautions.
Introduces instructions for configuring installations and maintaining logs.
Emphasizes checking pins, wires, and lighting settings before energizing.
Guides GTX 335 configuration using the Setup Wizard Tool.
Details GTN configuration for TIS-A display functions.
Provides instructions for configuring GNS 400W/500W units.
Outlines ground checks for interfaces in configuration mode.
Covers ground checks for interfaces in normal mode.
Details performance checks for GPS, regulatory, ADS-B Out, and EMC.
Ensures proper completion of AFMS and checkout logs.
Provides pinout information for the GTX 335 transponder.
To Next Page