Why does my Garmin Two-Way Radio take so long to get a location fix?
If your Garmin Two-Way Radio takes more than ten minutes to get a location fix, it might be because the unit's view of satellites is obstructed. Try moving to a location with a clear view of the sky.
What to do if my Garmin Two-Way Radio does not turn on even with new batteries?
If your Garmin Two-Way Radio does not turn on, even with new batteries, ensure that the batteries are installed correctly. If not, reinstall them. Also, make sure you press and hold the Power button for 2 seconds, instead of just pressing and releasing it.
Why can't my Garmin Rino 130 Two-Way Radio access a WAAS system satellite?
If your Garmin Two-Way Radio cannot access a WAAS system satellite after 2 to 5 minutes, it may be caused by an obstruction in your view of the satellite, or you may be located too far from satellites currently in service for the Americas. Move to a location with a clear view and point the unit antenna in the direction of the satellite. Also, check that the system GPS operation is set to ‘Normal’ and the interface is set to other than RTCM, or simply turn off WAAS.
Why can't my Garmin Rino 130 Two-Way Radio get a differential position from WAAS?
If your Garmin Two-Way Radio cannot obtain a differential position from WAAS, it may be because you have not collected enough information from the WAAS satellite. Wait 10–20 minutes for the initial collection, then 1–2 minutes afterwards.
Why does my Garmin Rino 130 Two-Way Radio turn on, then turn off?
If your Garmin Two-Way Radio unit turns on, then turns off, the batteries may be nearly exhausted. Replace them.
How to see the panning arrow on the Map Page easily on Garmin Two-Way Radio?
If you cannot see the panning arrow on the Map Page easily on your Garmin Two-Way Radio, it may be because there is too much map clutter, or the scale is such that map features are too densely displayed. Use the Map Page Setup Page to reduce map clutter or change the map scale.
Why can't my Garmin Rino 130 Two-Way Radio access Point of Interest, Street, or Intersection Find Lists?
If your Garmin Two-Way Radio cannot access Point of Interest, Street, or Intersection Find Lists, the MetroGuide map data is not activated. Access the Map Setup ‘Map’ option and activate the check box.
How to view a track being laid down on the map page on Garmin Two-Way Radio?
If you cannot view a track being laid down on the map page when traveling with your Garmin Two-Way Radio, the Track Log feature is turned Off. Access the Tracks Page, highlight the ‘On’ button and press the THUMB STICK IN.
General| Outdoor (hiking, trekking) | Yes |
|---|---|
| Marine (chartplotters, sounders) | No |
| Routes quantity | 20 |
| Number of waypoints | 500 |
| Form factor | Handheld |
| Grayscale levels | 4 |
| Display resolution | 160 x 160 pixels |
| RS-232 ports | 1 |
| Internal memory | 24 MB |
| Number of tracklog points | 10000 |
| Battery type | AA |
| Battery life (max) | 14 h |
| Number of batteries supported | 3 |
Weight and Dimensions| Depth | 16 mm |
|---|---|
| Width | 58 mm |
| Height | 114 mm |
| Weight | 236 g |
To Next Page
