Garrard ZERO 100C - Instructions for Use; Manual Single Record Play; Automatic Record Play

INSTRUCTIONS FOR USE
To play a single record manually
Fit the short, single record spindle into th
contre of the platter and press it down into
place.
2 Place a record on the plattor, using the
‘adaptor provided if the racord has a large
contro hele.
{3 Set the record speed selector to 33) or 45
rev/min as roquired by the record to be
layed, and the cartridge tilting lever to M.
4 Move the manual operating control tab fully
t0ON.
5 (a) Lower the tonearm onto the record by
hand iting itt the Wont of the arm
(b) Move the cueing control tab to LIFT,
then placa the tonearm ever any desired
point on the record and return the con
‘To play a stack of records automatically
1 Fit the long automatic record epindlo into
‘me centre of the platter and turn the spindle
Until it can be pressed down to bo held in
place.
2 (a) 12in records ~ loag up to six records
fon to the step of tho apindie with the
‘edge of the sack resting on the recore
platform. Pull the rocord stoady up.
‘wards then inwards and release it to
tetum to the top of the records to
stabilise them.
Tin records with large centre holes.
Place the LRS100 large record spindle
(available from your dealer as an op-
tional extra) over the automatic recora
spindle and load a stack of up to seven
Tin recards level onto its step.
(c) Tin records with small centre holes. Use
tho Garrard type AB record platform
adaptor (available trom your dealer as
(
trol tab towards PLAY to lower the tone:
arm gently.
‘After playing the rocord tho tonearm will
Feturn to its rest and the unit will switch off
‘To play @ single record automatically
1 Fit the shor, single record spindle and place
the record on the platter, using the adaptor
Provided it the record has a large centre
hale.
2 Set tho record speed and size solector for
the record to be played, For example, 33 12
for a 33} rev/min 12in record,
Set the cartridge titing lever to M,
4 Move the automatic operating control fully
to START and hold it there for a second oF
two before releasing it. After playing the
record the tonearm will return to its rest and
the unit will switch oft.
an optional extra complete with instruc-
tions for use)
8 Set the record speed and size selector for
the records to be played. For example, set
89 12 for 364 rev/min 12in records.
4 Set the cartridge tilting lover to A,
5 Move the automatic operating control tab
{ully to START and oid it here for a second
‘or two botore releasing it. When the records
hhave all been played the tonearm will return
to its rest and the unit will switch oft.
8 To unload the records - lft them clear of the
record spindle, even it they are to be tTe-
played immediately. When using the LRS100
spindie lift the records with the fingers of
both hande while pressing down on the top
of the spinale witn the thumbs