Garrard ZERO 100C - Page 3

INTRODUCTION
The Garrard Zero 1002 is a super’ two-speed
transcription tumntadie with such special foa-
* an ingenious tonearm virtually without track:
ing ertor (Patent applied for) with damped
eveing action,
* An automatic record counter. This new fea
‘uve (Patent applied for) indicates when a
diamoné-tipped stylus should be checked for
wear, Dased on the number of LP. records
Played
a magnetic tonearm artiskating system
Patent applied 101),
a motor with the advantages of both induc
tion and eynchronaus motors (Patented)
2 record speed and pitch control system
with builtin stroboscopic checking,
vice to set the cartridge tracking
BRIEF TECHNICAL SPECIFICATION
Powot Supply Voltage: 110/126V AC or 110/120
land 220/240V AC dependent on tha motor coll
windings. Power supply requirements. are
shown on the motor.
Power Supply Frequency: 50 or 6042 depen-
dent on the interchangeable motor pulley and
stroboscopic turntable titted
Power Consumption: Approximately 0 watts.
Speeds: $33 and 45 rev/min. Both speeds can
be varied by plus or minus 3%. Accuracy of
speed is checked by means of an illuminated
Stroboscope
Motor: A 4:pole induction rotor section to pro-
vide the starting torque and a synchronous
Section’ for constant’ running speed. It is
slliently mounted.
Tonearm (Pickup Arm): The tonearm head
pivots laterally 2s it tracks a record to main
tain negligible tracking error. The magnetic
‘addition to manual operation the Zero 100¢
will automatically play single Tin (17em), 10in
25cm) and 12in (30cm) 1ecords, oF a stack of
up {3 six.12in. records the number. will
depend upon the thickness. o! the records.
Adaptors aro available to play records with
large centre holes and to play a stack of Tin
records
Naturally, you will be keen to put your turn
table info use es soon as possible but, as you
fealise, its a precision instrument. For this
reason, we sirongly advise you to read the
Instructions betore installing or operating it so
{hat you will obtain the full bonett of ite many
‘capabilities.
WARNING: To provent fite oF shock hazard, do
not expose this appliance to rain or moisture.
tonearm anti-skating system is calibrated tor
doth conical (spherical) and cllipticel cart.
Nidge styl.
A tilting arrangement allows the cartridge to be
‘set in position to give the correct tracking angle
when playing a single record or, alternatively,
at the height of three records for automatic
play
itis lifted and lowered gently by viscous damp-
ing
Size: Approximately 142in (375mm) wide, 134in
(885mm) deep and 6gin (170mm) high,
Weight: Approximately 113Ib (5.2k9).
* A mounting base and dust cover. |
* A record spindle adaptor Type LASI00 to
lay up to six recorge with tin (38mm)
contre holes automaticaly.
* A record platform adaptor Type AB to pl
Up to six 7in diameter records with small
contro heles automatically