Garrison 1028313 - Exhaust Hose Installation

INSTALLATION INSTRUCTIONS
Exhaust hose installation:
The exhaust hose and adapter must be installed or removed
in accordance with the usage mode.
The exhaust hose can be compressed or extended
moderately according to the installation requirement,
but it is desirable to keep the hose length to a minimum.
1. Install Adapter B and Adapter I onto the exhaust hose as
shown in Fig. 16a or Fig. 16b. Refer to the previous pages for
window kit installation.
2. Reinsert the hook of the exhaust hose into the hole seat of the
air outlet and slide it down along the arrow direction (See Fig. 17)
for installation.
IMPORTANT:
DO NOT OVER BEND THE EXHAUST HOSE ( Fig. 19).
12
Fig.16a
Fig.17
Fig.19
The Exhaust hose can be installed into the wall
(Not applicable for units without Adapter A, expansion
plugs, and wooden screws).
1. Prepare a hole in the wall. Install the wall exhaust Adapter A
onto the wall (outside) by using 4 expansion plugs and
wooden screws. Be sure to fix thoroughly (Fig. 18).
2. Attach the exhaust hose to wall exhaust Adaptor A.
Fig.18
max 120CM
min 30CM
Adapter A
Expansion plug
position
Adapter
cap
Note:
Cover the hole using the adapter cap when not in use.
Fig.16b
COOL, HEAT (heat pump-type), or AUTO
mode
FAN, DEHUMIDIFY, or HEAT (electrical heat-type)
mode
Install
Remove
CAUTION:
Make sure that there is no obstacle around the air outlet of
the exhaust hose (in the range of 500mm) to ensure the
exhaust system works properly.
Hole seat
Hook