EasyManua.ls Logo

GAS GAS EC 2008 - User Manual

GAS GAS EC 2008
74 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
MANUAL DEL USUARIO
USER MANUAL
MANUEL D’ENTRETIEN
LIBRETTO D´USO
BETRIEBSANLEITUNG
enducross EC´08
enducross EC´08
enducross EC´08

Questions and Answers

  • P
    Paul RobertsSep 16, 2025
    What causes handlebar vibration on my GAS GAS EC 2008?
    • S
      Susan BallardSep 16, 2025
      If your GAS GAS Motorcycle is experiencing handlebar vibration, excessive steering axles tolerances, loose handlebar bracket, and loose handlebar stem locknut can be the cause. Tighten steering bracket and steering stem locknut to the correct torque values.
  • G
    Gabriela RobinsonAug 25, 2025
    What causes detonations from the exhaust pipe on my GAS GAS EC 2008 Motorcycle?
    • P
      Pam JohnstonAug 25, 2025
      If your GAS GAS Motorcycle has detonations from the exhaust pipe, it could be due to carbon build up in the combustion chamber, so you should clean the combustion chamber. It may also be caused by incorrect octane or poor quality gasoline, so you should drain all the gasoline and fill up with a higher octane fuel. A damaged spark plug or incorrect specifications can also cause detonations, so replace the spark plug with a new one of the correct type. Finally, deteriorated exhaust system gaskets can be the cause, so verify if the exhaust system is damaged and replace all gaskets if necessary.
  • W
    wvaldezAug 25, 2025
    What to do if my GAS GAS Motorcycle engine lacks power or has poor acceleration?
    • B
      Brittany GibsonAug 26, 2025
      If your GAS GAS Motorcycle engine lacks power or has poor acceleration, you can try the following: * Clean the fuel system and verify its operation. * Clean or replace the air cleaner and verify its operation. * Check the exhaust system for damage and replace the muffler fiberglass packing if necessary. * Disassemble the carburetor and clean all jets. * Replace the crankshaft bearings. * Verify the clutch operation, but it's recommended to go to a specialized workshop for this.
  • M
    Mrs. Kelly YoungAug 26, 2025
    What to do if my GAS GAS EC 2008 Motorcycle engine does not crank?
    • J
      Jorge BennettAug 26, 2025
      If your GAS GAS Motorcycle engine does not crank, here are a few things you can try: * Drain old fuel out of the tank and refill with new fuel. * Clean, dry, or replace the spark plug. * To relieve the engine, accelerate to max speed, press the starter pedal 5 or 10 times, then try starting the engine. If it still fails, remove and dry the spark plug. * Clean the fuel tank air vent and adjust the air cleaner duct. * Verify the exhaust valve and repair if necessary. It is also recommended to go to a specialized workshop.
  • N
    Nichole GonzalezSep 16, 2025
    Why does my GAS GAS EC 2008 engine operate irregularly?
    • P
      Patricia BrightSep 17, 2025
      If your GAS GAS Motorcycle engine operates irregularly, it could be due to a damaged ignition rotor, which should be replaced. It could also be caused by water in the fuel, so drain the fuel tank and fill up with new fuel.
  • S
    suzanne40Sep 23, 2025
    Why is there brown smoke coming out of the exhaust pipe of my GAS GAS EC 2008 Motorcycle?
    • B
      Bridget LopezSep 23, 2025
      If you see brown smoke coming out of the exhaust pipe of your GAS GAS Motorcycle, it could be due to a restricted air cleaner. Clean or replace the air cleaner and go to a specialized workshop. Another possible cause is the main jet set too high, so verify the main jet operation and go to a specialized workshop.
  • I
    iparsonsSep 7, 2025
    What to do if the brakes do not operate correctly on my GAS GAS EC 2008?
    • J
      Joel WilliamsSep 8, 2025
      If the brakes do not operate correctly on your GAS GAS Motorcycle: * Replace the discs. * Verify the brake circuits and replace any damaged or broken parts. * Drain the brake fluid and fill with the new fluid recommended by the manufacturer. * Replace the pump piston. * Adjust brakes.
  • M
    maryolsonSep 8, 2025
    What to check if light bulbs are blown on my GAS GAS Motorcycle?
    • P
      Paul SmithSep 8, 2025
      If you are experiencing blown light bulbs on your GAS GAS Motorcycle, remove the seat and the fuel tank, and check all connections, the voltage regulator, and the fuses in the fuse box.
  • C
    Clayton MckinneySep 2, 2025
    What should I do if my GAS GAS EC 2008 Motorcycle's shock absorber is set too hard?
    • G
      Gregory GonzalezSep 2, 2025
      If your GAS GAS Motorcycle's shock absorber feels too hard: * Pour excess oil until reaching the correct oil level. * Drain fork oil and fill with correct fork oil viscosity. * Check tire air pressure. * Adjust rear shock absorber. It is also recommended to go to a specialized workshop and replace the front fork.
  • M
    Mia BishopAug 31, 2025
    Why does the engine on my GAS GAS EC 2008 operate irregularly?
    • U
      uwilcoxAug 31, 2025
      If the engine on your GAS GAS Motorcycle operates irregularly: * Verify the spark plug condition and clean, tighten, or replace it. * Verify the spark plug cap condition and replace it if deteriorated.

Summary

Engine and Transmission Specifications

Chassis, Brakes, and Dimensions

Fuel System Information

Starting the Engine

Shifting Gears and Stopping the Engine

Break-In Period Riding

Maintenance Schedule - Part 1

Maintenance Schedule - Part 2

Engine Systems Maintenance

Spark Plug and Transmission Maintenance

Transmission Oil Management

Procedures for checking and changing transmission oil.

Air Cleaner Maintenance

Throttle Cable and Carburetor Adjustment

Clutch and Exhaust System Maintenance

Drive Chain Guide and Adjustment

Drive Chain Slack Adjustment

Handlebar and Brake Adjustments

Rear Brake, Brake Fluid, and Steering

Steering Adjustment and Blockage

Front Fork Adjustment - Overview

Front Fork Adjustment - Details

Rear Suspension and Compression Adjustment

Bolts and Nuts Tightening Locations

Torque Value Specifications

Drive Chain Lubrication and Carburetor Tuning - Mixture

Carburetor Tuning - Idle, Jets, and Symptoms

Carburetor Tuning - Spark Plug and Correction Factors

Suspension Tune-Up - Front Fork

Suspension Tune-Up - Rider and Terrain Factors

Suspension Tune-Up - Compatibility and Curve Handling

Suspension Tune-Up - Potholes, Jumps, and Gearshift

Multifunction Display Overview

Multifunction Display Function Details

Setting Multifunction Display Parameters - Basic Settings

Setting Multifunction Display Parameters - RPM and Pulse

Setting Multifunction Display Parameters - Temperature and Gear Warnings

Setting Multifunction Display Parameters - Danger RPM and Reset

Troubleshooting - Engine Issues

Troubleshooting - Performance, Noise, and Smoke

Troubleshooting - Transmission and Stability

Troubleshooting - Suspension, Vibration, and Brakes

Troubleshooting - Lighting System Malfunctions

GAS GAS EC 2008 Specifications

General IconGeneral
BrandGAS GAS
ModelEC 2008
CategoryMotorcycle
LanguageEnglish

Related product manuals