GAS GAS EC 2008 User Manual (English)

Questions and Answers:

M
Mrs. Kelly YoungAug 26, 2025
What to do if my GAS GAS EC 2008 Motorcycle engine does not crank?
- J
  Jorge BennettAug 26, 2025
  If your GAS GAS Motorcycle engine does not crank, here are a few things you can try: * Drain old fuel out of the tank and refill with new fuel. * Clean, dry, or replace the spark plug. * To relieve the engine, accelerate to max speed, press the starter pedal 5 or 10 times, then try starting the engine. If it still fails, remove and dry the spark plug. * Clean the fuel tank air vent and adjust the air cleaner duct. * Verify the exhaust valve and repair if necessary. It is also recommended to go to a specialized workshop.
W
wvaldezAug 25, 2025
What to do if my GAS GAS Motorcycle engine lacks power or has poor acceleration?
- B
  Brittany GibsonAug 26, 2025
  If your GAS GAS Motorcycle engine lacks power or has poor acceleration, you can try the following: * Clean the fuel system and verify its operation. * Clean or replace the air cleaner and verify its operation. * Check the exhaust system for damage and replace the muffler fiberglass packing if necessary. * Disassemble the carburetor and clean all jets. * Replace the crankshaft bearings. * Verify the clutch operation, but it's recommended to go to a specialized workshop for this.
W
wilsonmichaelAug 23, 2025
What to do about detonations from the exhaust pipe on my GAS GAS Motorcycle?
- D
  David LawsonAug 23, 2025
  If you're experiencing detonations from the exhaust pipe of your GAS GAS Motorcycle, try the following: * Clean the combustion chamber. * Drain all gasoline and fill up with a higher octane fuel. * Replace the spark plug with a new one of the correct type. * Verify if the exhaust system is damaged and ensure all gaskets are in perfect condition, replacing them if necessary.
M
Maria MillsSep 14, 2025
Why is the shock absorber on my GAS GAS Motorcycle set too hard?