Gasboy Atlas 9100 series - User Manual

MDE-4809 Atlas™ 9100 Series Totalizer Retrofit Kit (M05813K004) Installation Instructions · May 2009 Page 1
Introduction
Purpose
This manual provides instructions to install the Lower Front Totalizer Retrofit Kit for Atlas
™
9100 Series Units (M05813K004).
Note: A new Bezel with a totalizer opening may be required when installing the kit. Use
templates to identify the correct Bezel.
Table of Contents
Topic Page
Introduction 1
Important Safety Information 3
Installation of the Lower Totalizer Retrofit Kit 5
Required Tools
The following tools are required for the installation of the kit:
• Phillips
®
Screwdriver
•Wrench
•Hammer and Punch
Parts List
The following table lists the parts included in this kit.
Item Description Part Number Quantity
1
Face Dial Blank Totalizer 025548 1
2 Nut Hex Keps W/EXT LW 6 Q12068-02 10
3 SCR SLF V/R 510500-325 S00702 1
4 Modified Gear Plate Assy 015891 1
5 Totalizer 8 WH VR 370016 S65336 1
6 SCR V/R 510500-327 S00704 2
7 Totalizer Seal V/R 28698K S00207 2
8 INSTR-9100 Series Front T 032933 1
9 8 X 10 X 4 200#C.K. R.S. 018072 1
10 CRTN 25-3/4X9-3/4X6-1/8 R 018116 1
MDE-4809
Atlas
™
9100 Series Totalizer Retrofit Kit
(M05813K004) Installation Instructions
May 2009

Summary

Introduction and Overview

Purpose of the Manual

Details the manual's objective to provide instructions for installing the Lower Front Totalizer Retrofit Kit.

Warranty Information

Directs users to Gasboy's Warranty Policy Statement for warranty-related inquiries.

Important Safety Information

General Safety Precautions

Covers preliminary precautions, emergency shut-off, working with electricity, and hazardous materials.

Understanding Warning Systems

Explains safety alert symbols and signal words like DANGER, WARNING, and CAUTION.

Preventing Fires and Explosions

Highlights risks associated with fuels, vapors, ignition sources, and electrical energy.

Emergency Procedures and Lockout;Tagout

Provides guidance for emergency response and the Lockout/Tagout procedure for safety.

Installation Procedures

Removing Existing Components

Instructions on removing the existing dial face, seal caps, and totalizer screws.

Removing the Totalizer and Bracket

Steps to detach the totalizer and remove the associated bracket from the unit.

Installing New Components

Guidance on installing the slotted gear plate and the front totalizer securely.

Finalizing Installation

Details on fastening the totalizer, installing seal caps, and reattaching the dial face.

Gasboy Atlas 9100 series Specifications