Need help?Do you have a question about the Gasboy atlas and is the answer not in the manual?
Instructions for operating, programming, and maintaining Atlas Fuel Systems pumps/dispensers.
Manual is for owners and operators of Atlas Fuel Systems pumps and dispensers.
Information on operating, preparing for service, and maintaining pumps/dispensers.
Lists abbreviations and acronyms used in the manual.
Working in a dangerous environment with flammable fuels requires trained individuals.
Locating and using the total electrical shut-off for emergencies.
Requires total electrical shut-off for access to electrical components.
Actions for procedures requiring access to pump/dispenser or STPs.
Discusses explosion and fire prevention when working with fuels.
Recommended actions for hazards like fuel spills and collisions.
Figures and information on internal and external components of pumps/dispensers.
UL-listed units, self-contained or remote-controlled, various models.
UL-listed 9100K units, self-contained or remote-controlled, mechanical non-computers.
Instructions for common functions on Gasboy Atlas pumps/dispensers.
Required equipment and materials for installing E85 units.
Cautions and considerations for DEF dispenser installation and operation.
Minimum tasks installer must perform for site preparation.
Requirements for UL approved and conductive hoses.
Describes operation and information on accessing components and setting switches.
Operation of pump/dispenser, accessing components, setting switches.
Setting communication rate for Gasboy RS-485 pump loop.
Setting mode (On-line or Standalone) for Series 9800.
Four/ten-position switch bank for address setting or pulser rate.
Selects Unit of Measurement: US Gallons, Imperial Gallons, and Liters.
Procedures for temporary pricing and calibration.
Unit programming divided into three levels; Level 1 codes explained.
Manager's keypad layout and use for programming.
Steps to program Price Per Unit (PPU).
Useful error codes for troubleshooting 8800 series.
Warning about incompatible materials with E85/DEF.
Operating sequence for the pump.
Operating sequence for the remote dispenser.
Sequence of events for pump operation.
Sequence of events for dispenser fueling.
Error codes displayed in standalone mode.
Error codes that appear on power-up.
Installation completion checklist and start-up procedure.
Voltage check and tightness inspection after start-up.
Instructions for preparing site for servicing by a Gasboy-trained ASC.
Contacting the Help Desk before calling an ASC.
Use only genuine Gasboy replacement parts and retrofit kits.
Importance of trained personnel for servicing Gasboy equipment.
Adjusting the reset motor if the unit fails to reset or shut-off.
Inspecting and changing strainers and filters regularly.
Table detailing components, frequency, maintenance, and who performs it.
Definitions starting with 'A' through 'D'.
Definitions starting with 'S' through 'V'.
General| Model | Atlas |
|---|---|
| Brand | Gasboy |
| Display Type | LCD |
| Power Supply | 120/240 VAC |
| Fuel Compatibility | Gasoline, Diesel, Ethanol blends |
| Card Reader | Optional |
| Warranty | 12 months |
| Category | Fuel Dispenser |
To Next Page
