Gate Titan Quick Start Guide

Firmware Editions09
Notice
In order to upgrade your TITAN rmware, you
need to purchase an upgrade. To do so, follow
the steps on our website:
www.gatee.eu/editions
Notice
You need USB-Link or Blu-Link to connect TITAN with GATE Control
Station for Android and Windows/macOS. To connect TITAN with
GCS iOS, you must use Blu-Link.
* GCS setting is a setting previously dened in GCS app, which value is not available for
selection in this programming mode. Once you change such setting to a dierent option during
programming via trigger and then exit this programming mode, it is no longer possible to set
that setting from this level (it can be still specied via GCS).
¹ Available only for TITAN V2 NGRS
² N/A for TITAN V2

Gate Titan Specifications

General

MOSFET	Yes
Battery protection	Yes
Trigger sensitivity adjustment	Yes
Pre-cocking	Yes
ROF control	Yes
Active brake	Yes
Diagnostic system	Yes
Programmable	Yes
Cycle Detection	Yes
Compatibility	V2 Gearbox
Low current consumption in sleep mode	0.2mA
Connectivity	USB-Link, Blu-Link
Fire Modes	Semi, Burst
Bluetooth support	Yes