Gate Titan Quick Start Guide

38
Turning on the programming mode*
1. Switch re selector position to SEMI
2. Fire a shot or burst
3. Keep the trigger pulled for 7 seconds
– until you hear a vibration
Turning on the programming mode – the second ‘backup’ method
1. Disconnect the battery
2. Pull the trigger
3. While the trigger is pulled, connect the battery (ignore warning vibrations)
4. Hold the trigger for 3 seconds – until you hear a vibration
* Not possible if Auto mode is assigned to SEMI position.

Gate Titan Specifications

General

MOSFET	Yes
Battery protection	Yes
Trigger sensitivity adjustment	Yes
Pre-cocking	Yes
ROF control	Yes
Active brake	Yes
Diagnostic system	Yes
Programmable	Yes
Cycle Detection	Yes
Compatibility	V2 Gearbox
Low current consumption in sleep mode	0.2mA
Connectivity	USB-Link, Blu-Link
Fire Modes	Semi, Burst
Bluetooth support	Yes