21
Replacing the hard drive in the hard drive kit
www.gateway.com
Replacing the hard drive in the
hard drive kit
Tools you need to complete this task:
Screws removed during this task:
To replace the hard drive in the hard drive kit:
1 Disconnect the AC adapter and modem and network cables and prepare
your notebook by following the instructions in “Preparing your notebook”
on page 7.
2 Turn your notebook over so the bottom is facing up.
3 Remove the battery by following the instructions in “Removing the
battery” on page 8.
4 Remove the hard drive kit by following the instructions in “Replacing the
hard drive kit” on page 18.
Phillips #0 screwdriver
2 chrome 2.5 × 4.7 mm
(hard drive kit)
2 chrome 3.0 × 3.5 mm
(hard drive kit bracket)
To Next Page
Loading...
