Using Your Gateway Flat-panel Monitor www.gateway.com
2
Connecting the monitor
To connect the monitor:
1 Place the monitor base on a table top, then slide the monitor neck down
onto the base until it clicks into place. You may need to press the two
buttons on the base to let the monitor slide on smoothly.
2 Position your computer and the monitor so you can reach the back of each.
3 Connect the power cord to the power connector under the back of the
display.
8511808.book Page 2 Friday, November 17, 2006 9:56 AM
To Next Page
Loading...
Need help?
General
