www.gateway.com
49
Removing the bay cover
To remove or replace components located on the lower bay, you need to remove
the bay cover first.
Tools you need to complete this task:
To remove the bay cover:
1 Complete the steps in “Preparing the notebook” on page 47.
2 Turn the notebook over so the base is facing up.
3 Loosen the bay cover screws (these screws cannot be removed).
4 Insert a non-marring plastic scribe on the cover’s notch to release the cover
from the computer, and then remove the cover.
Phillips #0 screwdriver
Non-marring plastic scribe
To Next Page
Loading...
