CHAPTER 3: Replacing notebook components
54
Replacing the hard drive
Tools you need to complete this task:
Screws removed during this task:
• 1 black M2×5 (hard drive)
• 2 chrome M3×3 (hard drive bracket)
To replace the hard drive:
1 Complete the steps in “Preparing the notebook” on page 47.
2 Complete the steps in “Removing the bay cover” on page 49.
3 Remove the hard drive screw.
4 Grasp the black mylar tab and use it to disengage the hard drive from its connector,
and then remove the drive from its compartment.
Phillips #0 screwdriver
Non-marring plastic scribe
To Next Page
Loading...
