Chapter 3: Managing Power Consumption 47
10.
Select
Save Changes & Exit
by pressing E
NTER
, then press E
NTER
again.
11.
At the next screen, select
Boot from CD-ROM
.
12.
Press E
NTER
. After the program loads memory for approximately 5 to
10 seconds, another screen appears.
13.
Select
Go to other options
by pressing the down arrow, then press E
NTER
.
14.
Select
Battery learning...
(of your particular notebook model) by
pressing the down arrow.
15.
Press E
NTER
. A screen with a description of the Battery Learning
Software appears.
16.
Press E
NTER
.
17.
After reading the last screen of instructions, press any key to continue.
18.
Type
Y
, then press E
NTER
. After a couple of minutes, a screen showing
the progress of the Battery Learning Software appears.
19.
Once the cycle is complete, follow the on-screen instructions.
To Next Page
Loading...
