Gateway Solo 9150 - Using the Power menu

56 Using Your Gateway Solo™ 9150 Notebook
The following table shows how to change the system modes in Windows 95
and Windows NT.
Using the Power menu
The Power menu is a part of the BIOS Setup Utility that contains the power
management settings. Use the Power menu to make changes to the
notebook to improve the battery-powered session time and performance.
The rest of the BIOS Setup screens are explained in Maintaining and
Troubleshooting Your Solo Notebook.
1.
Start your notebook.
2.
Press the F2 key when prompted to do so.
If your
notebook
is...
...and you
want to...
then do this
Off Start up Press the power button.
On Suspend Click Start, then Suspend.
In Suspend
mode
Resume
power
Press the power button briefly.
On Shut down Click Start, Shut Down, Shut down the
computer, then click Yes.
To access the Power menu