Chapter 3: Managing Power Consumption 55
Using Standby mode in Windows 98
Windows 98 uses Standby mode (which is referred to as Suspend mode in
Windows 95). When in Standby mode, your notebook enters a sleep state,
cutting off power to most devices except memory.
The following table shows how to change the system modes in
Windows 98.
Windows 95 and Windows NT
To manage your power management settings in Windows 95 and
Windows NT, you need to go into the BIOS Setup program and change the
power management settings. See “Using the Power menu” on page 56 for
more information on these settings and how to modify them.
Using Suspend mode in Windows 95 and Windows NT
Windows 95 and Windows NT use Suspend mode (which is referred to as
Standby mode in Windows 98). When in Suspend mode, your notebook
enters a sleep state according to the power management settings. Suspend
mode cuts off power from most devices except memory.
If your
notebook
is...
...and you
want to...
...then do this
Off Start up Press the power button.
On Standby Click Start, Shut Down, Standby, then
click OK.
- OR -
Press
F
N
+F4.
In Standby
mode
Resume
power
Press the power button briefly.
On Shut down Click Start, Shut Down, click Shut Down
again, then click OK.
To Next Page
Loading...
