Gateway Tablet PC - Page 233

223
Adding or replacing memory
www.gateway.com
To add or replace memory modules:
1 Follow the instructions under “Preventing static electricity discharge” on
page 221.
2 Turn off your tablet PC and disconnect the AC adapter and modem and
network cables.
3 Disconnect your tablet PC from the optional FlexDock (see “Using the
Tablet PC FlexDock” on page 227).
4 Place the hard top on the front of your tablet PC.
5 Turn your tablet PC over so the back is facing up.
6 Remove the battery. For more information, see “Changing batteries” on
page 131.
7 Remove the two memory bay cover screws.
Screws