GAUI X5 - Preflight, Post-Flight, and Maintenance

17
GAUI
TAI SHIH HOBBY CORPORATION
Preight Check
飛行前檢查
8.檢查尾舵伺服機垂直90度時尾舵角片是否也垂直90度。(1-4.1-5)
9.確認尾螺距最大最小行程是否順暢無干涉(1-6.1-7)
10.確認尾螺距正反向是否正確(1-8)
(1-8)
(1-6)(1-4)
(1-7)(1-5)
5
1.各部位螺絲是否有確實鎖緊。(1-1.1-2.1-3)
2.馬達齒是否與主齒盤正確契合 P.9。(1-2)
3.傳動齒輪間隙是否正確 P.12。(1-2)
4.電子系統是否確實固定無鬆動。(1-2)
5.電池固定位置是否正確。(1-2)
6.主槳是否已互相平衡。(1-1)
7.橫軸、主軸、尾橫軸、軸承等是否順暢或以潤滑油做適當補充。(1-1.1-3)
8.連接馬達時請依電源顏色做相接。
(1-1) (1-2)
(1-3)
90
o
90
o
1. Check all screws are tighten rmly. (1-1,1-2,1-3)
2. Check gear mesh between motor gear and main gear are
corresponding to each other. P9 (1-2)
3. Check gear mesh between transmission gears. P12 (1-2)
4. Check electric devices are xed rmly (1-2).
5. Check battery are xed rmly (1-2).
6. Make sure main blades are well balanced (1-1).
7. Check spindle, main axis, tail axis, bearings are running
smoothly and well lubricated. (1-1, 1-3)
8. Check wires between motor and ESC are correctly connected.
8. Check angle of tail servo are precisely 90 degree, and tail rotor linkage are precisely 90 degree. (1-4, 1-5)
9. Check travel range of tail rotor pitch, and making sure they are running smoothly (1-6,1-7).
10. After power on, check the pitch travel direction of tail rotor are correct according to heading direction.
5mm~10mm