GB Instruments Wire-Tracker GET-4110K, LAN-Tracker GET-4220K User Manual

4
Fold the plug or clip out and close
the housing door. Connect the
transmitter to the wiring and press
the On/Off button to activate.
Activate the receiver by depressing
the On/Off button and continuing to
hold down. Bring the receiver near
the transmitter and check for the
audible and visual signals. This
verifies that both units are functioning
properly. Trace wiring by following
the audible and visual signals that
the receiver is producing.
To prevent interference, disconnect
the house line from the main
telephone company service. This can
be done by locating the junction box
where the house is connected to the
telephone company wiring. Remove
any connections from the house to
this box, making sure to note the
proper location of each wire for later
reconnection. Use the RJ-11
(telephone) plug for insertion into a
standard telephone jack. Trace the
wiring as described above.
Tracing Telephone Wiring

GB Instruments Wire-Tracker GET-4110K, LAN-Tracker GET-4220K Specifications

General

Brand	GB Instruments
Model	Wire-Tracker GET-4110K, LAN-Tracker GET-4220K
Category	GPS
Language	English