50
Attaching Infant Carrier to Base
Make sure handle is locked in Position A (see page
20). ALWAYS verify that the handle is LOCKED in the
Position A before lifting Infant Carrier by the handle.
An unlocked handle could move unexpectedly,
causing child to fall out.
Lift Infant Carrier by the Handle and slide the
Attachment Rod under the Attachment Catch on the
Base.
Rotate foot end of the Infant Carrier down onto the
Base until an audible CLICK is heard.
IMPORTANT: The green Safety Button will pop out
from the middle of the Infant Carrier Release to
indicate proper attachment.
ALWAYS have the handle locked in Position A while
using this child restraint in a vehicle.
CHECK: Lift up on Handle to ensure that the Infant
Carrier is securely attached to the Base.
Extend the L.S.P ( Linear Side Impact Protection)
device.
2
3
1
USING THE INFANT CARRIER WITH THE BASE
CLICK!
1
2
3
To Next Page
Loading...
