32
To Remove from Storage:
To install the Base using LATCH, the
Connectors must be removed from their storage
compartments.
To access the LATCH Connector Storage
compartments, squeeze the Level Adjustment
Handle to fully extend the Leveling Foot.
Remove each connector by pushing the red
button while pulling out.
Lengthen the strap between the connectors
using the LATCH Strap Adjuster located next to
the connector on the right-hand side. Push down
on the Adjuster button while lengthening strap.
REMOVING AND STORING LATCH CONNECTORS
1
2
3
1
2
3
To Next Page
Loading...
