Page 4-1
ProCut 17P – Installation and Operating Instructions
WARNING: Do not attempt to service or repair
the machine. Failure to observe this warning could
result in severe personal injury or death.
Disconnect the plug from the receptacle and contact
GBC Technical Service when one or more of the
following has occurred.
• The power supply cord or attachment plug is
damaged.
• Liquid has been spilled into the machine.
• The machine is malfunctioning.
• The machine does not operate as described
in these instructions.
GBc technIcal servIce
United States
1-800-723-4000
Canada
Ontario and Quebec – 1-800-268-3310
All other Provinces – 1-800-268-3447
Local 905-595-3100
Mexico
(55) 1500-5778
PrIor to InstallatIon
Inspect the crate and machine for damage. Shipping
damage should be brought to the immediate
attention of the delivering carrier.
WARNING: Do not attempt to move the
machine across anything other than a at, level
surface without trained and qualied riggers. You
can be severely injured or crushed.
The ProCut 17P Series Cutter is a large and heavy
piece of equipment. It is not designed to be tipped
up or tipped sideways in anyway.
Prepare the site:
1. Allow enough room to access all sides of the
machine. Refer to the illustration on the next
page.
2. Ensure the floor is stable and a flat surface
capable of supporting the weight of the machine
and any materials. All four foot pads should be
able to be positioned completely on a level and
smooth surface.
InstallatIon
There are no operator serviceable parts to the
machine other than periodic cleaning. Refer to the
Operator Maintenance chapter.
During installation, observe the safety regulations
applicable for your country.
WARNING: A trained GBC Technician MUST
install the machine for the rst time. Failure to
observe this warning could result in severe bodily
injury or death.
CAUTION: Do not attempt to install the machine
yourself for the rst time. You could damage the
machine.
4. InstallatIon
To Next Page
Loading...
Need help?
General
