Page 6-1
640t – Installation and Operating Instructions
This chapter describes how to use the laminator to:
Operate the machine•
Load films (web the machine)•
Laminate items•
Mount items•
ge n e r a l op e r a t i o n
These instructions assume that the lms have been
loaded. For information about loading lms, see
“Loading Film” on page 6-2.
Fig. 6-1. Control Panel.
To run the laminator:
Turn the laminator 1. On (I) with the power switch
located at the back of the machine.
The Display (“Fig. 6-1. Control Panel.”) is:
Set at • COLD or 32*
Speed • 9
Ready to run•
Set the Roller Pressure Handle for High 2.
Lamination (“Fig. 6-2 Roller Pressure Handle.”).
WARNING: Make sure the print clamp and
feed tray are in their proper positions. Your ngers
and hands could be trapped and crushed in the
rollers. Clothing, jewelry, and long hair could be
caught in the rollers and pull you into them.
Fig. 6-2 Roller Pressure Handle.
Set the Roller Pressure Handle for the thickness 3.
of the item that is to be laminated or mounted.
Set the desired speed on the control panel.4.
Press 5. RUN or the foot switch.
The rollers will begin to turn.
Position the item or items to be laminated or 6.
mounted on the feed table.
Push the item(s) squarely into the roller nip point 7.
(where the two rollers meet).
Additional items can be laminated or mounted
without stopping and starting the machine.
Release the 8. foot switch or press STOP to
stop the laminator when all of the items have
completely exited the rear of the machine.
6. op e r a t i o n
To Next Page
Loading...
Need help?
General
