GBC GBC4250 - Rollers, Film Path, and Other Parts; Film Loading & Threading

8
The ‘Word Finishing" People
L. P ULL ROLLERS- The set of rollers located at the back of the laminator.
These rollers are motor driven. They are used to simultaneously pull the
laminate and improve the quality of the laminated item.
M. FILM
CUTTER: Use
to cut the film
web at the area
at which the web
exits the
laminator.
N. REVERSE
SWITCH: Used
to facilitate
removing a
jammed (wrap-
up) condition.
The pull rollers
are caused to
rotate in the
reverse direction. The laminating film is pulled back into the laminator when
the Reverse Switch is depressed.
O. LINE FUSE- Located in the fuse holder which is positioned on the rear of
the equipment.
P. CORE CLIPS- Mounted on the Supply Roll Shaft. Used to hold the film roll
to the supply roll shaft.
Q. FILM WEB- Laminating film loaded into the equipment.
R. NIP POINT- The point at which the top and bottom rollers contact. The
Nip Point of the heat rollers is the place at which items for lamination are
introduced into the laminator.
FILM LOADING & THREADING
Refer to figure 4 or the film threading diagram located beneath the feed table
on the inner side panel of the laminator for illustration of properly loaded film.