GBC GBC4250 - Page 9

9
The "Word Finishing” People
THREADING DIAGRAM
LAMINATOR SIDE VIEW
The top and bottom rolls of laminating film must be of the same width and
must be present simultaneously. A small amount of adhesive will "squeeze
out” during lamination. Hardened adhesive deposited on the rollers may
damage the heat rollers. Rotate the rollers at the "Slow” speed setting only to
avoid damaging the rollers, when the laminator has not achieved full
operating temperature as indicated by a flashing Wait lamp. Refer to the sec¬
tion entitled CARING FOR THE GBC425Q LAMINATOR for instructions
regarding removal of the accumulated adhesive.